Kingston HyperX FURY 16GB DDR4 2400MHz HX424C15FB/16

HyperX Fury
HX424C15FB/16

HyperX HX424C15FB/16 is a 2G x 64-bit (16GB) DDR4-2400 CL15
SDRAM (Synchronous DRAM) 2Rx8, memory module, based on
sixteen 1G x 8-bit FBGA components per module. Each module kit
supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0.
Each module has been tested to run at DDR4-2400 at a low latency
timing of 15-15-15 at 1.2V. Additional timing parameters are
shown in the Plug-N-Play (PnP) Timing Parameters section
below. The JEDEC standard electrical and mechanical
specifications are as follows:

JEDEC/XMP TIMING PARAMETERS

JEDEC/PnP: DDR4-2400 CL15-15-15 @1.2V
DDR4-2133 CL14-14-14 @1.2V
XMP Profile #1: DDR4-2400 CL15-15-15 @1.2V

SPECIFICATIONS

CL(IDD)-15 cycles
Row Cycle Time (tRCmin)-46.75ns(min. )
Refresh to Active/Refresh-350ns(min. )
Command Time (tRFCmin)
Row Active Time (tRASmin)-29.125ns(min. )
Maximum Operating Power-TBD W*
UL Rating-94 V - 0
Operating Temperature-0oC to +85oC
Storage Temperature- -55oC to +100oC

FEATURES

Power Supply: VDD = 1.2V Typical
VDDQ = 1.2V Typical
VPP - 2.5V Typical
VDDSPD = 2.2V to 3.6V
Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
Low-power auto self refresh (LPASR)
Data bus inversion (DBI) for data bus
On-die VREFDQ generation and calibration
Dual-rank
On-board I2 serial presence-detect (SPD) EEPROM
16 internal banks; 4 groups of 4 banks each
Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
Selectable BC4 or BL8 on-the-fly (OTF)
Fly-by topology
Terminated control command and address bus
Height 1.340 (34.04mm), w/o heatsink

HyperX is a division of Kingston.