Dynacord PowerMate PM 1000-3

Reference-Powermixer, 2x 1000 W RMS/4 Ohm, 6+4 channels , 12+4 channels SPECIFICATIONS: Channels (Mono + Stereo) 6 + 4 Auxiliaries (MON, FX, AUX) 2 Pre, 2 Post, 2 Pre/Post switchable Maximum Midband Output Power, 1 kHz, THD=1%, Dual Channel: into 2.66 Ohms 2 x 1350 W into 4 Ohms 2 x 1000 W into 8 Ohms 2 x 600 W Rated Output Power, THD=0.1%, Single Channel: into 4 Ohms 2 x 900 W into 8 Ohms 2 x 450 W Maximum Output Voltage of power amplifier, no load - 74 Vrms THD at 1kHz, MBW=80kHz : MIC input to Master A L/R output, +16 dBu, typical < 0.005% POWER AMP INPUTS to Speaker L/R output < 0.075% DIM 30, power amplifier, 60Hz, 7kHz < 0.05% IMD-SMPTE, power amplifier, 60Hz, 7 kHz < 0.015% CMRR, MIC input, 1 kHz > 80 dB Equivalent Input Noise, MIC Input, A-weighted, 150 ? -130 dBu Signal/Noise-Ratio, power amplifier, A-weighted, 4 Ohms 105 dB Output Stage Topology, amplifier Class D Equalization: LO Shelving +/- 15 dB / 60 Hz MID Peaking, mono inputs +/- 15 dB / 100 Hz . . 8 kHz MID Peaking, stereo inputs +/- 12 dB / 2.4 kHz HI Shelving +/- 15 dB / 12 kHz Master EQ, 11-band (63, 125, 250, 400, 1k, 1.6k, 2.5k, 4k, 6.3k, 12kHz: +/- 10 dB / Q = 1.5-2.5 Filter: LO-CUT, mono inputs f=80 Hz, 18 dB/oct VOICE FILTER, mono inputs FEEDBACK FILTER, MON1/2 70 Hz . . 7 kHz, Notch, -9 dB Speaker Processing LPN, switchable Display High Contrast OLED Effects: Type Dual stereo 24/48-bit multi effects processors Effects presets 100 Factory + 20 User, Tap-Delay Remote control Footswitch, MIDI Digital Audio Interface Channels 4 In / 4 Out AD/DA Conversion 24bit Sampling Rate 44.1 / 48 / 88.2 /96 kHz PC Interface USB 2.0, Female Type B MIDI Interface 5-pin DIN connector, In / Out Output Power Control Adjustale RMS Limiter Protections Mixer Outputs (Relay controlled) MON1, MON2, MASTER A Amplifier Audio Limiters, High Temperature, DC, HF, Short Circuit, Peak Current Limiters, Turn-On-Delay