Kingston HyperX Beast 8GB (2x4GB) DDR3 2133MHz HX321C11T3K2/8

8GB (2x 4GB) DDR3 2133MHz, HyperX Beast (T3), powered by Kingston
HX321C11T3K2/8

FEATURES
JEDEC standard 1.5V (1.425V ~ 1.575V) Power Supply
VDDQ = 1.5V (1.425V ~ 1.575V)
800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 11, 10, 9, 8, 7, 6
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
8-bit pre-fetch
Burst Length: 8 (Interleave without any limit, sequential with starting address 000 only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
Asynchronous Reset
Height 1.827 (46.41mm) w/ heatsink, single sided component

SPECIFICATIONS

CL(IDD) 11 cycles
Row Cycle Time (tRCmin) 48.125ns (min. )
Refresh to Active/Refresh 260ns (min. )
Command Time (tRFCmin)

Row Active Time (tRASmin) 35ns (min. )

Maximum Operating Power TBD W* (per module)
UL Rating 94 V - 0

Operating Temperature 0o
C to 85o C

Storage Temperature -55o
C to +100o C

*Power will vary depending on the SDRAM used