Dynacord CL 800

Power Amplifier 2x400W, Class AB Topology The new Compact Linear Precision Series power amplifiers combine outstanding audio performance with maximum reliability and operating security as well as being markedly lighter than equivalent power amplifiers. Through the use of an optimized power supply with low dispersion toroidal transformers as well as of Class AB technology, a large amount of headroom above the specified nominal output has been achieved along with a considerable reduction in weight and thermal leakage. Specifications: Load Impendance 2, 4, 8 Ohm Max. Midband, Output Power, THD = 1%, 1kHz , Dual Channel 2 Ohm - 600W, 4 Ohm - 400W, 8 Ohm - 240W Rated Output Power, THD < 0,1%, 20Hz … 20kHz 4 Ohm - 300W, 8 Ohm - 150W Max. Single Channel, Output Power, Dynamic Max. Single Channel, Output Power, Continuous, 1kHz 2 Ohm - 800W, 4 Ohm - 480W, 8 Ohm - 270W Max. Bridged, Output Power, THD = 1%, 1kHz 4 Ohm - 1200W, 8 Ohm - 800W Maximum RMS Voltage Swing, THD = 1%, 1kHz 50V Power Bandwith, ref. 1kHz, THD =1%, half power @ 4 ohms 10Hz … 60kHz Voltage Gain, ref. 1kHz 32,0 dB Input Sensitivity, at rated output power +1,15 dBu (0,88 V rms) THD at rated output power MBW = 80kHz, 1kHz IMD-SMPTE, 60Hz, 7kHz < 0,02% DIM 30, 3,15kHz, 15kHz < 0,01% Maximum Input Level +22 dBu (9,76 V rms) Crosstalk, ref. 1kHz, at rated output power < -80 dB Frequency Response, ref. 1kHz (- 1dB) 15Hz … 40kHz Input Impedance, active balanced 20 kOhm Damping Factor, 1kHz > 300 Slew Rate 25 V/s Signal to Noise Ratio, Amplifier, A-weighted 103,5 dB Output Noise, A-weighted < -70 dB Output Stage Topology Class AB Power Requirements 100V, 120V, 220V, 230V, 240 V; 50Hz … 60Hz (factory configured) Power Consumption 1/8 max. , output power @ 4 Ohms 600W (Measured with 110% of reated mains voltage) Protections Audio limiters, High temperature, DC, HF, Back-EMF, Peak current limiters, Inrush current limiters, Turn on delay Cooling Front-to rear, 3-stage fans